A Theoretical study on the charge and discharge states of Na-ion battery cathode material,Na1+xFePO4F

Na₂FePO₄F is a promising cathode material for a Na-ion battery because of its high electronic capacity and good cycle performance. In this work, first principle calculations combined with cluster expansion and the Monte Carlo method have been applied to analyze the charge and discharge processes of Na₂FePO₄F by examining the voltage curve and the phase diagram. As a result of the density functional theory calculation and experimental verification with structural analysis, we found that the most stable structure of Na_1.5FePO₄F has the P2₁/b11 space group, which has not been reported to date. The estimated voltage curve has two clear plateaus caused by the two-phase structure composed of P2₁/b11 Na_1.5FePO₄F and Pbcn Na₂FePO₄F or Na₁FePO₄F and separated along the c-axis direction. The phase diagram shows the stability of the phase-separated structure. Considering that Na₂FePO₄F has diffusion paths in the a- and c-axis directions, Na₂FePO₄F has both innerphase and interphase diffusion paths. We suggest that the stable two-phase structure and the diffusion paths to both the innerphase and interphases are a key for the very clear plateau. We challenge to simulate a nonequilibrium state at high rate discharge with high temperature by introducing a coordinate-dependent chemical potential. The simulation shows agreement with the experimental discharge curve on the disappearance of the two plateaus. © 2018 Wiley Periodicals, Inc.     

QEPAS系统中石英音叉模态仿真计算与研究

对石英音叉增强型光声光谱(QEPAS)系统中常用的石英音叉进行了有限元模态计算，获得石英音叉前6阶振型与模态频率，认知了第4阶对称摆动振型为有效振动，利用单因素法分析了石英音叉的音臂长度l₁、音臂宽度w₁、音臂厚度t、音臂切角θ、音臂圆孔直径d及音臂圆孔高度h对低阶有效共振频率(Fre)的影响，敏感度依次为： l₁> w₁>d>θ>t>h，考虑实际设计情形，筛选出了l₁，w₁，d与h四个石英音叉设计变量，采用Box-Behnken实验设计方案与RSM(response surface methodology)方法，以Fre为函数目标，建立l₁，w₁，d与h的二次回归响应面模型，得到了参数之间的交互作用，利用Design-Expert软件对响应面模型进行设计参数反求，结果表明，在15 000 Hz≤Fre≤25 000 Hz计算区域内误差较小，基本满足QEPAS系统的计算需求，所提出的研究与设计方法具有一定通用性，可为QEPAS系统中石英音叉结构参数设计提供参考。     

Periodic Solutions of the Duffing Differential Equation Revisited via the Averaging Theory

We use three different results of the averaging theory of first order for studying the existence of new periodic solutions in the two Duffing differential equations $\ddot y+ a \sin y= b \sin t$ and $\ddot y+a y-c y^3=b\sin t$, where $a$, $b$ and $c$ are real parameters.     

Formation of intermediate coupling optical polarons and bipolarons in two-dimensional systems

The formation of the optical polaron and bipolaron in two-dimensional (2D) systems is studied in the intermediate electron–phonon coupling regime. The total energies of the 2D polaron and bipolaron are calculated by using the Buimistrov–Pekar method of canonical transformations. The obtained results are compared with other existing results obtained by using the Feynman path integral method and the modified Lee–Low–Pines unitary transformation method. It is shown that the electron–phonon correlation significantly reduces the total energy of the 2D polaron in comparison with the energy of the strong coupling (adiabatic) polaron. It is found that the polaron formation in 2D systems is possible when the electron–phonon coupling constant α is greater than the critical value ${\alpha }_c?2.94$, which is much lower than a critical value of the electron–phonon coupling constant α in three-dimensional (3D) systems. The critical values of the Fröhlich coupling constant α and the ratio $\eta ={\epsilon }_{\infty }/{\epsilon }_0$ (where ${\epsilon }_{\infty }$ and ${\epsilon }_0$ are the high frequency and static dielectric constants, respectively), which determine the bipolaron stability region in 2D systems, are calculated numerically. It is interesting for application to the layered cuprate superconductors that the (bi)polarons are formed more easily in quasi-2D regions than in the bulk. It is argued that the high-$T_c$ cuprate superconductivity can exist above the bulk superconducting transition temperature $T_c$ as the persisting superfluidity of polaronic (bosonic) Cooper pairs and large bipolarons at quasi-2D grain boundaries or in the CuO₂ layers above $T_c$.     

A new endocytic model based on the co-rotational grid method

Endocytosis plays important roles in many cellular physiological processes, such as metabolism and immune. Many theoretical models have been proposed to study the endocytic process, but little has considered the tensile deformation of the membrane and the actin forces. In this paper, a new endocytic model is proposed based on the co-rotational grid method. Our model gives a direct estimation of the in-plane strain of the plasma membrane and provides a basis for the calculation of further scission process of the vesicle. The results fit well with experimental data in the literature. Moreover, it is suggested that the active forces of actin at the endocytic site is the main mechanism driving the invagination of the plasma membrane.     

棒状LiZnPO4的低温合成与表征

LiZnPO₄的性能与其形貌密切相关,其合成常用的固相法和水热法均无控制其微观形貌的优势。 本文采用改进的沉淀法成功合成了具有棒状结构的LiZnPO₄。 利用热重-差热分析仪(TG-DSC)、X射线衍射仪(XRD)、傅里叶变换红外光谱(FTIR)以及场发射扫描电子显微镜(FE-SEM)等技术研究了LiZnPO₄形成过程、晶相组成、微观结构和形貌。 同时探究了合成方法、煅烧温度、煅烧时间、酸的种类对LiZnPO₄形貌的影响。 结果表明,相比较于固相法,以醋酸为原料的改进沉淀法不仅可以有效降低LiZnPO₄的合成温度至500 ℃,而且很容易控制棒状LiZnPO₄的形成。 在600 ℃下煅烧2 h后可以获得分散性良好、横截面为矩形、直径约为2 μm的规则棒状LiZnPO₄。 此外,对比颗粒状LiZnPO₄和棒状LiZnPO₄的光响应能力,发现棒状LiZnPO₄的光响应能力明显增强。     

一类改进最大熵方法的可调参数分析

在结构可靠性分析中,引入含可调参数的转换函数能对传统的最大熵方法进行改进,获得更高的失效概率预测精度。但是,此可调参数的最佳取值很难确定。针对这一问题,引入概率守恒方程,从功能函数转换前后所得概率密度函数出发,建立其最大熵值的变化关系,给出转换前后最大熵值之差的理论形式。通过对三种典型单调非线性转换函数开展算例研究,发现功能函数转换前后的最大熵值之差与转换函数的最佳可调参数值有关。改变可调参数值驱使最大熵值之差变化的同时,改进最大熵方法能遍历到更好的失效概率估计值。     

基于CEEMD的重大事件对香港住宅价格影响的实证分析

应用互补集成经验模态分解（CEEMD）方法对香港1997―2018年的住宅价格月度数据进行了分解，将经过重构后的数据分成高频序列、低频序列与残差项。将BP多断点检测应用于低频序列，并结合样本时段内的重大事件进行实证分析。结果表明：1997年亚洲金融风暴对房价的影响大于2008年金融危机；外部经济体的救市政策间接地影响香港房价；在经济不景气的大环境下“孙九招”政策没有立即见效；资本投资者入境计划、住房供给调整与按揭贷款调整对房价的影响较为显著；税收调整对房价影响不显著、对交易量影响显著；SARS爆发使住宅价格下降约1%。     

Na原子链表面等离激元特性的含时密度泛函研究

本文用含时密度泛函理论研究了线性Na原子链的表面等离激元机理.主要在原子尺度下模拟计算了体系随着原子数增加及原子间距变化的集体激发过程.研究发现线性原子链有一个普遍的特性——存在一个纵模和两个横模.两个横模一般在实验上很难被观测到.纵模随着原子链长度增加,能量红移的同时,该纵模主峰的强度呈线性增长.随着原子个数的增加,端点模式(TE)开始蓝移,能量和偶极强度都逐渐趋向饱和.横模能量被劈裂的原因概括如下:(一)每个位置的电子受到的势不同,在两端的电子受到的势要比在中间的电子受到的势要高,因此两端的电荷积累也比中间多;(二)端点存在悬挂键,所以中间的电子-电子间相互作用与端点的不一样,这两方面又都与原子间距d有关.